For the plastic drawer Consists of three parts container cap and stents.The three parts should be fitting very well otherwise will be easy stuck.
On the bottom of the drawer there has two parts design as limit position avoid the drawing drop outer.
Drawer will be easy deformation if the injection parameter is not adjusted well or the cooling condition is not good.We must find some method to avoid this deformation.
The plastic melting and shrinkage are also very important for plastic drawer mould.
If you’re interested in this mould pls kindly contact with us.
Link to this article：Plastic drawer mould supplier
Reprint Statement: If there are no special instructions, all articles on this site are original. Please indicate the source for reprinting:Mold Wiki，Thanks！^^